Making sure your power tools are protected from any harsh elements that can damage them can take its toll sometimes. Garage and basements is not a good place to store our tools because the humid environment is very harsh for them Here are a few tips to cut off your time in cleaning them .
To get more sound advice as well as knowledge with regards to woodworking plans have a look at my different blog sites here woodworking plans
Every time you purchase a power tool it is always covered with a waxy and think coating to prevent the rust from eating up your power tools and this is known as cosmoline. But as soon as it riches your place or shop these are being removed and the tools are left unprotected . There are times that the woodworkers would just wash the cosmoline entirely without thinking of its future protection .
To protect cast iron surfaces, you must apply a coating that will keep the air and moisture away. Buying commercially used rust preventive stuffs can be the one of the easiest way to do it . There are actually 2 brands that you can purchase they are the Empire Top Saver and Boeshield T-9.Both of these sprays are applied directly to the surface and then rubbed down to remove the excess. This step should be repeated periodically to keep a layer of protection on the tool.
Regardless of how safe we are able to keep our tools it is no guarantee that it will be protected from the rust . And not checking the tools for a long time will eventually lead to more damages.
This jointer was left unprotected. You can already see the increase in sawdust that invites rust to settle. After a couple of years this cast iron will need care.
In the earlier days people still use a steel wool to remove rust but how about the dust that is settled where the wool can't reach . Luckily there are products that can do the job for you.
Here comes Boeshield a rust remover that can make your chore a bit easier. This spray on rust remover works well on the tops of tools that are too large to soak in rust removal solutions. To use Rust Free you need to spray it on the rusted areas, wait a minute, and then just wipe dry. If the rust persists, just apply again and use an abrasive such as steel wool or a synthetic abrasive pad to remove the remaining rust.
Now that the jointer is free from rust you may apply rust protection on it. If you look closely you can see a small rust pit. These pits are the unavoidable consequence of the rust. No method of rust removal can fill in a rust pit once the rust has consumed the metal.
It is advisable that before you use the rust removal you must arm yourself with goggles and gloves to ensure your protection because rust removal are made of acids and these acids removes rust rather quickly.
Keeping your power tools rust free shouldn't be hard at all just follow the steps provided and you will be all set.
